Forklifts

Workplace Conditions That Can Lead to Forklift Accidents

Surface or ground conditions are an important part of safe powered industrial truck operation. In today’s Advisor we focus on hazardous conditions in your workplace that can lead to forklift accidents.

Physical conditions in the workplace that can lead to forklift accidents include slippery conditions, obstructions and uneven surfaces, flooring and load limits, overhead clearances, and ramps and grades.

Slippery Conditions

Hazards

  • Danger of skidding when traveling on oil, grease, water or other spills 
  • Danger of tipover when traveling on ice, snow, mud, gravel and uneven areas

Safe Practices

  • Avoid the hazardous surface when feasible.
  • Spread absorbent material on slick areas that you cannot avoid.
  • Cross the slippery area slowly and cautiously. 
  • Report the area to prevent others from slipping.
  • Post a sign or warning cones until the area can be cleaned.
  • Drive slowly!
  • Maintain contact with the ground by crossing uneven areas at an angle.
  • Clean up the oil or grease spill before proceeding (driving over an oil or grease spot will enlarge the hazardous area).

Obstructions and Uneven Surfaces

Hazards

  • Danger of tipover when traveling over obstructions
  • Danger of tipover in holes and bumps

Whatever safety meeting you need, chances are you’ll find it prewritten and ready to use in BLR’s Safety Meetings Library on CD. Try it at no cost or risk. Here’s how.


Safe Practices

  • Keep all aisles clear.
  • Watch out for overhead obstructions.
  • Avoid the obstruction or get off the forklift and remove the obstruction. 
  • Never drive straight across speed bumps or railroad tracks. Cross slowly at a 45-degree angle.
  • Maintain steering control by keeping contact with the ground at all times.
  • If an area is cluttered, walk the route first to spot problems.

Flooring and Load Limits

Hazard

  • Danger of collapsing floor

Safe Practices

  • Observe posted floor loading limits.
  • Inspect the condition of the floor. Look for holes or weakened flooring, loose objects or obstructions, protruding nails or boards.
  • Inform a supervisor immediately if flooring is defective.
  • Do not travel over a surface that cannot support the weight of the lift truck, its load, and its operator.
  • Do not enter a boxcar or semi-van without inspecting its floor and knowing its load limits.

Overhead Clearances

Hazards

  • Danger of tipover
  • Damage to lights, stacks, doors, sprinklers, pipes
  • Damage to load

We challenge you to NOT find a safety meeting you need, already prewritten, in BLR’s Safety Meetings Library. Take up our challenge at no cost or risk. Get the details.


Safe Practices

  • Be aware of the height of fixtures.
  • Don’t travel with loads elevated.

Ramps and Grades

Hazards

  • Danger of tipover
  • Damage to load

Safe Practices

  • Always look in the direction of travel.
  • Never turn on a ramp or incline. Turn prior to the ramp or incline to place forks in proper direction.
  • Keep a safe distance from the edge of a ramp. 
  • Do not travel on ramps with slopes or other conditions that exceed the manufacturer’s recommendation.
  • When traveling with a load, make sure the load points up the incline, regardless of the direction of travel.
  • When traveling without a load, make sure the load points down the grade, regardless of the direction of travel.
Print

1 thought on “Workplace Conditions That Can Lead to Forklift Accidents”

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.